أخبار الشركة عن Precautions For The Use of Decking Floor Sheet Machine?

Before the equipment is used, check whether the connections are secure and whether the installation bolts and nuts are tightened. The left and right chassis should be lubricated with lubricating oil to start the machine after power-on. First, run the vehicle and observe carefully, whether there is vibration, noise, oil window Whether oil comes, whether the movement of each part is coordinated, and the mold can only be installed after everything is normal. When installing the mold, you must cut off the power and manually move the motor belt or large gear to index the worktable and raise the slide to the highest point. It is best to use an object to support between the worktable and the bottom surface of the slide, so that the anti-skid seat naturally falls, causing an accident.
The mold used in this machine needs an upper mold and six lower molds of the same size. First install the upper mold and one lower mold. The lower mold is directly installed on the hexagonal runner table, and the upper mold is installed on the bottom surface of the slide, and Place a pad of appropriate thickness to ensure that after the upper and lower molds are closed, the gap between the four sides is uniform, and the distance between the upper and lower molds is equal to the required thickness of the tile blank. Then, based on the upper mold, the worktable is indexed, and the remaining five lower molds are installed. After all the upper and lower molds are installed, the tile can be driven to drive.